Railex Continuous Speed Rail System Components provide some of the best and sturdy support for any overhead conveyor system.
Ceiling Bolt:
- For fastening suspension pipes directly from wooden beams
- Lag end screws into 1/4" inch hole drilled in beam
- Opposite end expands into suspension pipe when tightened
- Provides sturdy support for suspensions
- Permits installation from floor level when suspension pipe is inserted in advance
Flange Clamp:
- For fastening suspensions to ceiling, brace pipes to wall, or uprights to floor
- Simply insert pipe and tighten non-slip nut
- Provides sturdy support not possible with other flanges
- Holes on 3.25" centers
Pipe Header Clamp:
For strapping pipe or tube headers to underside of I, T or L beams. Low cost, fast installation.
Jack Set:
- For supporting uprights between floor and ceiling
- Includes both floor and ceiling sections
- Hexagon nut tightens to jack upright between floor and ceiling
- Adjusts for differences in ceiling height or irregularities in floor
- Holes on 3.25" inch centers
Suspension Clamp (Beam, Angle or Channel):
- For suspending pipe or tubing from I, T, or L beams, channel, or angle
- Quickly attaches to beam
- Permits vertical adjustment of 1" inch
Suspension Clamp (Adjustable):
- For suspending pipe or tubing with 1 hole or 2 hole mounting angle and for supporting equipment from pipe suspensions when clamp is reversed
- Permits vertical adjustment of 4"
- Mounting angle pivots to 45°
2 Hole Flange and Nipple:
- 2 hole mounting for use as upright base plate
- One piece weldment
- Holes on 3.25" inch centers
Flange and Nipple 1 Hole:
- Single center hole mounting for use as upright base plate
- Uses FA5015 anchor for concrete floors of FL3110 lag bolt for wood floors
- One piece weldment
Suspension Clamp:
For suspending pipe or tubing with hole mounting.
Strap:
Heavy duty for strapping headers and braces to beams, trusses, angles, and other structurals.
Base, Dished 20" x 20"
Floor stand for uprights. Flared Edge. Four 3/8" mounting holes.
