RiveTier II Long Span Shelving

F.O.B. San Dimas, CA - Plano, TX - Paris, KY
Color: Gray

The Economical High-Performance Storage System
While RiveTier II is manufactured from the same high-quality steel as RiveTier I, its design offers the following significant advantages:

• Common “T” Posts - an economical starter/adder system
• Mitered beams reduce the number of parts - No need for separate left-to-right (LR) and front-to-back (FB) beams
• Low-cost units - cost per shelf is lower than RiveTier® I
• Heavy duty posts available for multi-level (catwalk) systems
• Four beam styles - to handle all your capacity requirements
• Assembles faster than metal shelving - saving 30-40% on installation costs
• No sway, cross braces, clips, corner gussets, nuts, bolts or cutting required
• Unobstructed shelf access from all four sides
• Heights up to 20 feet without splices
• Shelves adjustable at 1-1/2" increments

"-4" models include standard Shelf-Support (SS) beams only.
“-4H” models include 14 ga. SS beams in conjunction with one STS.
“-4HC” models include 14 ga. channel SSC in conjunction with one or two Shelf-Tie-Support (STS) depending on the width of the unit and use SS beams for bottom shelf level. All 96” wide shelves include two STS per level.

Standard finish is powder coated in gray - special colors are available with added cost and delay. All primary components are manufactured from 14ga. steel. All units are 7' high and sold without decking. Adder units (T-Posts) are not recommended for heavy-duty or seismic applications. If units must conform to seismic requirements contact us for assistance.

Note: RiveTier® II is not interchangeable with RiveTier® I or RiveTier® III